H-3.Checking The Operation Of The Paper Deck - Canon 1000 Service Manual

H-3. Checking the Operation of the Paper Deck
Step
1 Wait until the copier completes its
warm-up period.
2 Place paper in the paper deck, and
select the paper deck as the source of
paper.
3 Place the Test Sheet on the copyboard,
and make copies.
Adjusting the Left/Right Registration
If the left/right registration when the paper
deck is used as the source of paper is not as
indicated (2.0 ±1.0 mm), perform the
following steps to make adjustments:
4 Start the copier's service mode, and
select 'FEED-ADJ' under 'ADJUST'.
5 While the FEED ADJ screen is
indicated, press the Start key.
6 Check the left/right registration; then,
adjust the image write start position in
main scanning direction and the image
write start position in sub scanning
direction using VSYC-ADJ. Thereafter,
adjust the no-image width using
MARGN-L/R/T/B.
If the left/right registration is not as indicated
after making adjustments in service mode.
7 Check to make sure that the left/right
registration is normal when copies are
made using paper from the copier's
cassettes.
8 Remove the four screws, and
disconnect the connector; then, detach
the paper deck heater.
COPYRIGHT © 2001 CANON INC.
Work
CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
Check to make sure of the following:
• There is not abnormal sound.
• The lifter operation is normal.
• The pickup operation is normal.
• The copy image is normal.
• The left/right registration of the copy image is normal.
Paper deck heater
5. INSTALLATION
Remarks
Connector
Screws
5-33