Canon 1000 Service Manual page 749

Sorter
Code
• Feeding motor (M8; faulty)
E510
• Low-speed feeding motor (M10;
E516
faulty)
The locking cam of the buffer path
unit fails to reach home position.
E517
• Push bar motor (M7; rotation
E522
failure)
• Reference wall motor (M6;
E523
rotation failure)
COPYRIGHT © 2001 CANON INC.
Cause
CANON CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
7. TROUBLESHOOTING IMAGE FAULTS/MALFUNCTIONS
• There is no clock signal from the clock
sensor (PI5) of the feeding motor for 250 ms
or more.
• There is no clock signal from the clock
sensor (PI23) of the feeding motor for 250
ms or more.
0001 The buffer sensor 1 does not detect
the position of the locking cam at the
correct timing (i.e., the sensor 1 may
be considered to be damaged; the
sensor 2 operates normally).
0002 The buffer sensor 2 does not detect
the position of the locking cam at the
correct timing (i.e., the sensor 2 may
be considered to be damaged; the
sensor 1 operates normally).
0003 The buffer sensor (1, 2) does not
detect the position of the locking cam
at the correct timing (i.e., the sensor 1/
2 or the locking solenoid 1/2 may be
considered to be damaged).
0004 The buffer sensor 1/2 does not detect
the position of the locking cam at the
correct timing (i.e., either the locking
cam solenoid 1 or solenoid 2 or both
are considered to be damaged).
0005 The buffer sensor 1/2 does not detect
the position of the locking cam at the
correct timing (i.e., either the buffer
sensor or the locking cam solenoid or
both may be considered to be dam-
age).
• The operation does not end within 2000 ms
after the motor drive signal has been gener-
ated.
• The operation does not end within 2000ms
after the motor drive signal has been gener-
ated.
Description
7-313