Canon 1000 Service Manual page 448

7. TROUBLESHOOTING IMAGE FAULTS/MALFUNCTIONS
c. Adjusting the Image Reading Start Position (ADJ-XY)
DISP COUNTER
ADJUST
FUNC
OPTION
TEST
1) Start service mode, and select ADJUST >
ADJ-XY.
2) While the ADJ-XY screen is on, press the Start
key.
• The appropriate copying mode will be set
automatically, and a copy is made with a
shift of about 20 mm as shown in Figure 7-
215.
3) If a portion of the image is missing, decrease
the setting of 'ADJ-X' and 'ADJ-Y'.
4) If an area outside the image area is copied, in-
crease the setting of 'ADJ-X' and 'ADJ-Y'.
5) Press the Start key once again, and check the
output.
6) Press the Reset key.
Figure 7-215
7-12
COPYRIGHT © 2001 CANON INC.
<M> ADJ-XY
<S>
ADJ-X
xxx
ADJ-Y
xxx
ADJ-S
xxx
ADJ-J
xxx
Figure 7-214
ADJ-X
20
20
CANON CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
<R>READY <P>READY
d. Adjusting the Pick-Up Timing (paper deck)
If a discrepancy is found in the image leading
edge margin on LTR copies made using the paper
deck, correct the problem by performing the follow-
ing steps:
1) Place three or more sheets of LTR paper in the
paper deck.
2) Start service mode, and select 'FUNC > P-UP-
TMG'.
3) Execute 'PK-ADJ-D'.
• The machine picks up a single sheet of pa-
per.
4) Execute 'AK-ADJ-D' for a total of three times to
pick up three sheets of paper.
5) When pick-up has ended, press 'D-SEND-D'.
<F>