Removing The Lens Scanner Motor (M4) - Canon 1000 Service Manual

4. Removing the Lens Scanner Motor
(M4)
1) Make preparations for parts associated with
the laser unit.
2) Disconnect the two connectors (J03 and J04)
on the laser scanner motor driver PCB; then,
remove the three screws [2] (M4) on the laser
scanner motor assembly.
Do not remove the M3 screw used
to keep the cover in place.
[2]
Figure 4-612A
COPYRIGHT © 2001 CANON INC.
[1]
CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
4. MECHANICAL SYSTEM
3) Feed the harness [3] of the connector
removed in step 2) under the laser scanner
motor.
4) Lift the laser scanner motor [4], and
disconnect the two connectors [5]; at this time,
work paying attention to the dust-proofing
glass of the motor assembly and the lens
found on the left and the right of the motor.
[3]
Figure 4-613A
[5]
Figure 4-614A
[4]
4-63