Multifeeder; Removing The Multifeeder Assembly; Removing The Pickup Roller, Feed Roller, And Separation Roller - Canon 1130 Service Manual

CHAPTER 7 PICK-UP / FEEDING SYSTEM
B. Multifeeder
1. Removing the Multifeeder
Assembly
1) Remove the right middle cover, right
front cover, right rear cover, right rear
face cover, and right front face cover.
2) Disconnect the two connectors [1], and
remove the four screws [2]; then, detach
the multifeeder assembly [3].
2. Removing the Pickup Roller, Feed
Roller, and Separation Roller
1) Remove the right middle cover.
2) Remove the two screws [1], and detach
the pickup roller cover [2].
3) Remove the resin E-ring [3], and pull out
the pickup roller [4] slowly (both front
and rear).
The pickup roller is se-
cured in position to the
shaft with a parallel pin.
Take good care not to drop
the pin when removing or
mounting it.
7-60
COPYRIGHT © 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.1 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
[3] [2]
[2]
[2] [2]
Figure 7-729
[1]
[2]
Figure 7-730
[4]
Figure 7-731
[1]
[1]
[3]