Canon 1000 Service Manual page 411

Step
8 Remove the two screws, and remove
the fixing assembly.
Be sure to fit the two screws
removed in step 6 in ad-
vance of this step.
9 Remove the two screws, and remove
the fixing assembly mount (front, rear);
then, remove the oil receptacle.
At this time, take care not to
drop the hose attached to
the oil receptacle.
10 Remove the screw, and remove the oil
tank; then, draw out the fixing oil from
the oil tank.
11 Return the fixing unit to its initial
position.
12 Remove the paper deck.
If the route of relocation is not flat and the copier is likely to be subjected to vibration for sev-
eral minutes, remove the hopper assembly to avoid caking of toner and take precautions to
keep the hopper assembly free of vibration. (See the instructions on how to remove the hop-
per assembly under VII. in Chapter 4.)
COPYRIGHT © 2001 CANON INC.
Work
CLC1000/1000S/3100 REV.2 MAY 2001 PRINTED IN JAPAN (IMPRIME AU JAPON)
Fixing assembly
Screw
Fixing assembly (rear)
Screw
Screw
5. INSTALLATION
Remarks
Screw
Oil receptacle
Fixing assembly
mount (front)
Screw
Oil tank
5-37