Set Up A Headset For A Single Phone - Cisco 7800 Series Accessories Manual

Headsets
Table 17: Cisco Headset 500 Series Parameters for Cisco IP Phone 8800 Series
Cisco Headset
Cisco Headset
521 and 522
Cisco Headset
531 and 532
Cisco Headset
561 and 562
Table 18: Cisco Headset 700 Series Parameters for Cisco IP Phone 8800 Series
Cisco Headset
Cisco Headset
730
Related Topics

Set Up a Headset for a Single Phone

You can configure a single phone or a group of phones for headset support. To configure a group of phones,
use the Common Phone Profile.
Procedure
Step 1
Sign into Cisco Unified Communications Manager Administration as an administrator.
Step 2 Select Device > Phone
Step 3
Locate the phone associated with the user.
Phone Firmware
Phone Firmware
Release 12.1(1)
or later
Phone Firmware
Release 12.1(1)
or later
Phone Firmware
Release
12.5(1)SR1 or
later, and the
latest device
package
Phone Firmware
Phone Firmware
Release 12.7(1)
or later
Accessory Support, on page 1
Cisco IP Phone 7800 and 8800 Series Accessories Guide for Cisco Unified Communications Manager
Product Specific Description and Usage Guidelines
Configuration
Parameter
Side USB Port The headset usually requires about 5 seconds to
upgrade.
Back USB Port
Side USB Port The headset usually requires about 5 seconds to
upgrade.
Back USB Port
Wireless The headset usually requires 5 to 15 minutes to
Headset upgrade, and the base LEDs light in sequence to show
Hookswitch the upgrade progress. The user can postpone the
Control upgrade up to 4 times.
Side USB Port If you are using the Y cable to connect the headset
base to the phone, then you must enable Wireless
Back USB Port
Headset Hookswitch Control.
If you are using the USB cable to connect the headset
base to the phone, then you must the appropriate USB
port.
Product Specific Description and Usage Guidelines
Configuration
Parameter
Side USB Port The headset usually requires about 5 seconds to
upgrade.
Back USB Port
Set Up a Headset for a Single Phone
27