D9887B Receiver - Base Unit - Cisco D9887B Installation And Configuration Manual

Appendix B
Specifications
D9887B receiver – base unit
Includes:
System –
Display type:
Display Configuration:
Keypad:
Front Panel Lockout:
Configurations Allowed:
Rear panel:
Remote Operation/Update Interface –
Type:
Rear panel indicators:
Connector:
Serial Remote operation interface –
Type:
Protocol:
Connector:
Front Panel Indicators –
Input LED:
Error LED:
AC Power –
Operating Voltage:
206
Display, keypad, embedded controller,
Chassis/case, Power Supply/line cord
VFD (Vacuum Fluorescent Display)
4 lines x 20 characters
Membrane switches
Password control, up to 10 alpha-numeric
characters (no punctuations or spaces allowed)
Single RDS – 8-Slot (Configuration 1)
Dual RDS – 4-Slot each RDS (Configuration 2)
Eight available slots
Six I/O interface slots
Two video output slots (Configuration
dependent)
Ethernet, 10/100
Link (Green LED), Activity (Amber LED)
RJ45
RS232
115, 8, N, 1
9-pin D-sub, male
Green indicates valid input on selected input
Off indicates no valid signal on the selected input
Constant Blinking Green for Configuration 2
units indicates one valid input and one invalid
input
Red indicates error is occurring
Off indicates no errors detected
95–135 VAC or 180–265 VAC
78-4043743-01 Rev A