Table of Contents
Advertisement
MODEL 7561-PSDS
PORTABLE SENSOR DISPLAY – STRAIN BRIDGE
Full-Screen Messages
Some errors may be so severe that the value displayed cannot be trusted. In these
cases, a full screen message is displayed that will obscure the value displays to ensure
a potentially invalid value is not acted upon.
Figure 12. Full Screen Messages
TABLE 5. FULL SCREEN MESSAGES
Message
Reason
The mV/V input exceeds the upper limit for the selected
INPUT HIGH
sensitivity range of the current calibration range
The mV/V input is below the lower limit for the selected
INPUT LOW
sensitivity range of the current calibration range
OVERLOAD
The input value exceeds the user level set as overload
UNDERLOAD
The input value is below the user level set as underload
TEDS
A TEDs device has been disconnected so the handheld is
DISCONNECTED
reverting to the last selected calibration range. (Click OK)
SESSION RESTORED
MULTIPLE
More than one TEDs device has been detected, and this is
TEDS ARE NOT
not allowed
SUPPORTED!
NEW TEDS DEVICE
A new TEDs device has been detected so default values will
USE SESSION
be used for all settings not held in the TEDs device itself
DEFAULTS
KNOWN TEDS
A TEDs device has been reconnected so all the user set-
DEVICE SESSION
tings from the previous session will be applied. (Click OK)
RESTORED
An error has been detected in the connected TEDs device.
TEDs ERROR
See displayed error code and refer to the error code table in
Code 0x0000
this manual
BATTERY TOO
LOW REPLACE
Battery is too low to start the handheld
IMMEDIATELY
,
NOTE
Note: Because the keypad gets locked during toolkit configuration, avoid swapping
TEDS devices while connected to the toolkit any full screen messages that may
appear will not be able to be dismissed.
Model 7561-PSDS User Manual |
Issue A
008-0752-00
sps.honeywell.com/ast
| 19
Advertisement
Table of Contents
