Adapting Thermostat Control; Installing Stages Of Thermostat Control - Honeywell Hometronic HCM 200d Operation

Adaptation

Adapting thermostat control

Adapting thermostat control
This chapter explains how to control the actuator of a room via
the Hometronic Manager. Thermostat control is used to heat or
cool a single room:
•

Installing stages of thermostat control

•
Setting stages of thermostat control
•
De-installing stages of thermostat control
The actuator of a room must be controlled via the device switch
HS 30 or HS 20.
A device switch HS 30 can be used (as a collection relay) for
feedback of the heat generation. The collection relay switches
the boiler on as soon as a relay in a zone under thermostat con-
trol is activated.
Installing stages of thermostat control
The setpoint adjuster HCW 22 or temperature sensor HCF 22
must be assigned to the same room in the HCM 200d. Otherwise
you cannot install the device switches HS 20/30 (more detailed
information on assigning is found in the operating instructions of
the HCW 22 or HCF 22).
Example: Installing thermostat control with two stages in the
living room (see Chapter "Functions" on Page 12).
Installation of the device switch HS 20/30 for thermostat control
has no effect on the maximum number of devices on the Home-
tronic Manager HCM 200d.
Change to the "Settings" submenu as described on Page 54.
►
Turn the Dial button until "In-
►
stallation" is selected.
The following text is displayed:
Press the Dial button.
►
The following text is displayed:
88
INSTALLATION
DE-INSTALLATION
FUNCTION EXPANSION
SENSOR FUNCTION
HEATING/COOLING
SHUTTER
DEVICES/LIGHTS
SENSOR