Setting Response Delay Of Shutters - Honeywell Hometronic HCM 200d Operation

Adaptation
Adapting sun protection function of a shutter
Turn the Dial button until the
►
desired temperature value is
selected, for example:
Press the Dial button.
►
The following text is displayed:
To change the temperature threshold value for sun protection
►
deactivation, proceed in a similar manner.
Sun protection is activated for the shutter of the living room from 18 °C and
deactivated again under 10 °C. The parameters set previously are valid for
shading.
Press the Back button in order to leave the submenu.
►
To control the sun protection function of the shutter based on the
room temperature, select the corresponding room in the "Select
sensor" menu. Then carry out the steps in Chapter "Setting tem-
perature-dependent sun protection (shading) of a shutter".

Setting response delay of shutters

To prevent shutters from opening and closing too often while the
sun protection function is active (e.g. when clouds pass over-
head), you can set a delay time.
You can set the following delay values:
Value
0
1
2
3
The delay applies for shading, sunrise and sunset and can be set
separately for rising and falling brightness values.
The longer the delay time, the slower the sun protection function
reacts to the changing brightness values.
80
Delay
off
short
average
long
OUTSIDE TEMP
Sun prot. on
Sun prot. off
OUTSIDE TEMP
Sun prot. on
Sun prot. off
18.0 C
10.0 C
18.0 C
10.0 C