Service Mode (For Installers Only) - Honeywell Hometronic HCM 200d Operation

Appendix
Help with problems

Service mode (for installers only)

In Service mode, you check the radio connection between the
central operating unit (HCM 200d) and another device (HR 80,
HC60NG). For this purpose, you swap test messages between
the HCM 200d and the HR 80 or HC60NG.
Sending test message from HCM 200d
Example: Send test message to HR 80.
Prerequisite: The HR 80 is installed.
Turn the adjustment dial on the HR 80 to the right until "Test"
►
appears in the display.
Press the Binding button on the HR 80 until "000" appears in
►
the display.
Switch to the "Settings" submenu at the HCM 200d as de-
►
scribed on Page 54.
Turn the Dial button until "Installation" is selected.
►
Press the Dial button.
►
The following text is displayed:
Press the Dial button.
►
The following text is displayed:
Select the room to which the
►
HR 80 is assigned and to which
you would like to send the test
message.
Press the Dial button.
►
The following text is displayed:
The HCM 200d sends a test message to the selected room every 5 seconds
while you are in this menu.
114
HEATING/COOLING
SHUTTER
DEVICES/LIGHTS
SENSOR
LIVING
DINING
KITCHEN
SLEEPING
LIVING
DINING
KITCHEN
SLEEPING
LIVING
DINING
KITCHEN
SLEEPING
*
*
*