Honeywell Hometronic HCM 200d Operation page 123

LED
Light-emitting diode.
Lifestyle
User-defined actions which guide
various devices
through a selectable sequence.
Main menu
Menu items which are displayed
when "MENU" is selected.
Manual mode
Refer to the Chapter on "Important
information on" from Page 9.
Module
Component of the Hometronic
system, device from Honeywell.
Optimization
The optimization function of the
HR 80 sets its setpoint before the
switching point in the time pro-
gram. In this way, the room tem-
perature is already reached at the
switching point. The optimization
time is limited to 3 hours.
Parameters
Basic system settings which can
be used when no other values are
entered (name, setpoints, offsets
etc.). If a time program is not
available, the basic system set-
tings (setpoints)
ing/cooling, shutters and light are
used.
Partial automatic mode
Refer to the Chapter on "Important
information on" from Page 9.
Presence simulation
Refer to the Chapter on "Important
information on" from Page 9.
Remote offset
and modules Temperature jump which can be
triggered by the remote control.
Sensor
Sensor, e.g. for the measurement
of wind strength, brightness, tem-
perature.
Setpoint
Refer to the Chapter on "Important
information on" from Page 9.
Setpoint temperature
Room temperature which is to be
reached.
Setting
The Hometronic Manager differen-
tiates between 3 settings: Heat-
ing/cooling (H), light/devices (L)
and shutters (R).
Slat inclination
Horizontal position of the individual
part of a blind (refer to the sun
protection function).
Standard display
Basic display in the display of the
Hometronic Manager. Is displayed
after the Back button has been
for heat-
pressed (possibly several times).
Submenu
All the menus with the exception of
the standard display and the main
menu.
Appendix
Glossary
117