Honeywell Hometronic HCM 200d Operation page 130

Appendix
Index
Room parameters
Factory settings ..............105
Setting ..............................37
Room temperature
Display..............................40
Room temperature sensor
HCF 22 .................................47
S
Safety note .............................6
Sensor ..................................93
Adapting setpoint..............95
Assigning to a room..........93
Reading setpoint ..............96
Service mode......................114
Receiving test message .115
Sending test message....114
Setpoint
Adapting that of a sensor .95
Reading that of a sensor ..96
Setpoint adjuster HCW 22 ....47
Setpoints
Changing ..........................33
Settings...............................108
Settings submenu
Changing to ......................54
Settings, factory..................103
Settings, system
Saving ..............................55
Shading
Factory settings ..............106
Temperatur depending .....78
124
Shutter
Adapting opening width ....75
Adapting slat inclination....77
Assigning to a sensor .......73
Setting response delay .....80
Setting temperature-
dependent shading ...........78
Shutter, ranges ...................108
Software version .....................6
Status display .......................43
Storey controller
Temperature control with
HCM .................................20
Submenu
Display..............................39
Submenu display
Changing to ......................39
Sun protection
Activating ..........................35
Factory settings ..............106
Function............................14
Of a shutter, assigning......73
Temperatur depending .....78
System parameters
Factory settings ..............104
System settings
Adapting ...........................99
Restoring ..........................56
Saving...............................55
T
Temperature
Ranges ...........................108
Temperature control
Via sensor/contact
switch................................93
With storey controller........20