Operating - Hitachi SH7032 Hardware Manual

Table 1.1 Features of the SH7032 and SH7034 Microcomputers (cont)
Feature
Interrupt controller
(INTC)
User break controller
(UBC)
Clock pulse generator
(CPG)
Bus state controller
(BSC)
Description
Nine external interrupt pins (NMI, IRQ0–IRQ7)
Thirty-one internal interrupt sources
Sixteen programmable priority levels
Generates an interrupt when the CPU or DMAC generates a bus cycle
with specified conditions
Simplifies configuration of an on-chip debugger
On-chip clock pulse generator (maximum operating frequency: 20 MHz):
•
20-MHz pulses can be generated from a 20-MHz crystal with a duty
cycle correcting circuit
Supports external memory access:
•
Sixteen-bit external data bus
Address space divided into eight areas with the following preset features:
•
Bus size (8 or 16 bits)
•
Number of wait cycles can be defined by user.
•
Type of area (external memory area, DRAM area, etc.)
 Simplifies connection to ROM, SRAM, DRAM, and peripheral I/O
•
When the DRAM area is accessed:
 RAS and CAS signals for DRAM are output
 Tp cycles can be generated to assure RAS precharge time
 Address multiplexing is supported internally, so DRAM can be
connected directly
•
Chip select signals (CS0 to CS7) are output for each area
DRAM refresh function:
•
Programmable refresh interval
•
Supports CAS-before-RAS refresh and self-refresh modes
DRAM burst access function:
•
Supports high-speed access modes for DRAM
Wait cycles can be inserted by an external WAIT signal
One-stage write buffer improves the system performance
Data bus parity can be generated and checked
3