Creating A New Workspace - Mitsubishi Electric MELFA CR750 Series User Manual

5.2.

Creating a New Workspace

Click [Workspace] -> [New Workspace］ or click (Ctrl + N). Creating a New Workspace screen is displayed.
Input the workspace name and title, and then click the [OK] button. The project edit screen is displayed, so set
the project name (arbitrary name), the communication method and the robot model for offline (both are the
information of the robot that you want to connect.), then click the [OK] button.
When you use the software Version 1.2 or earlier, the project edit screen is not displayed.
When you use the software Version 3.20W or later, you can change the robot model of 3D monitor to the simple
model. Please refer to "12.1.5 3D Monitor" for the content of simple model.
Version 1.3
or later
Version 1.2 or earlier
Figure 5-3 Creating a New Workspace
The project tree is displayed in the workspace and the "RC1" project is created as the default value.
This project name can be change later. For details, see "5.9 Changing a Project Name".
If you want to display robot model of the simple model in the 3D monitor, check the checkbox of same label.
5-59 5-59