Mitsubishi Electric MELFA CR750 Series User Manual page 120

8.6.4.17. Comment Selection/Uncomment Selection
The selected lines are exchanged as a comment by the batch. Or the comments in the selected lines are
removed comment by the batch.
This function can be used in Ver. 1.2 or later.
In command edit screen, after selecting the lines you want to change into the comment, click [Edit]->[Comment
Selection] on menu bar. Comment character " ' " is added to the head of the selected lines.
Moreover, after selecting the lines you want to release the comment, click [Edit]->[Uncomment Selection] on
menu bar. Then the comments in the selected lines are removed comment.
However, even if you select the line where "Rem" command is included, "Rem" is not removed.
Example for setting / removing of comment is as follows;
program language
MELFA-BASIC V
MELFA-BASIC IV
Caution
Caution for comment in the robot program in debugging status
When the program is opened in debugging status, it is written as soon as the comment is set or
removed. At this time, when the robot controller is driving, it becomes an error.
8-120
Comment Selection
Uncomment Selection
Figure 8-40 Comment Selection / Uncomment Selection
Table 8-3 Example for setting / removing comment
Set comment Remove comment
8-120