Mitsubishi Electric MELFA CR750 Series User Manual page 204

(2) In the case of using version 2.50C or earlier
After you change the parameter value, you can rewrite the parameters in the robot controller by clicking the
[Write] button.
Figure 11-61 Ethernet parameter (Version 2.50C or earlier)
You can reference explanations of displayed parameters by pressing the [Explain] button.
Select the device to edit and double click. A screen is displayed for setting a variety of device information.
Figure 11-62 Device parameter setting (Version 2.50C or earlier)
If you check the [Change the Parameter to connect Vision] checkbox, the items from "Port" downward take on
the values for a network vision sensor.
Caution
Using a CRn-500 series robot controller
When using Ethernet with a CRn-500 series robot controller, the "Ethernet interface" option is required.
11-204 11-204