8.6.4.15. Renumbering
The renumbering function can only be used with MELFA-BASIC IV and Movemaster commands.
You can renumber line numbers in a batch. You can specify the range for renumbering.
With the setting dialog, you can specify the start and end lines numbers, the new starting line number, and the
line number interval.
While editing a program created with MELFA-BASIC IV or Movemaster commands, click the tool bar [Tool] ->
[Renumber]. The renumber set screen is displayed.
Caution
Renumbering can only be used with MELFA-BASIC IV and
Movemaster commands.
The renumbering function can only be used with MELFA-BASIC IV and Movemaster commands.
It can not be used with standard MELFA-BASIC V.
8.6.4.16. Sorting
The sorting function can only be used with MELFA-BASIC IV and Movemaster commands.
This sorts the edited program by line number.
While editing a program created with MELFA-BASIC IV or Movemaster commands, click the tool bar [Tool] ->
[Sort]. The confirmation message is displayed, then the line numbers are sorted in ascending order.
Caution
Sorting can only be used with MELFA-BASIC IV and Movemaster
commands.
The sorting function can only be used with MELFA-BASIC IV and Movemaster commands. It can
not be used with standard MELFA-BASIC V.
8-119
Figure 8-38 Renumber Setting Screen
Figure 8-39 Sorting
8-119