11.3.
Movement Parameters
11.3.1. Motion limit parameter
Set the operating range of the robot
Set parameters while connected to the robot controller.
From the project tree, double click the target project [Online] -> [Parameter] -> [Movement parameter] ->
[Motion limit].
After you change the parameter value, you can rewrite the operating range parameter in the robot controller by
clicking the [Write] button.
Figure 11-8 Motion limit parameter (Ver.1.2 or later)
Figure 11-9 Motion limit parameter (Ver.1.1 or earlier)
You can reference explanations of displayed parameters by pressing the [Explain] button.
11-166
11-166