Edit Of Parameter Changed From Initial Value - Mitsubishi Electric MELFA CR750 Series User Manual

11.1.3. Edit of parameter changed from initial value

It is possible to confirm the changed parameter by displaying the list of parameter changed from an initial
value. This function has the limitation in this software version and the software version of the connected
controller. Please refer to the table as follows.
or earlier
Version of
this software
When combination of "not use", the button for the display switch is not displayed in the upper part of the
screen
When the parameter list is displayed after connecting with the controller of corresponding version, the button
for the display switch is displayed in the upper part of the screen.
When the parameter list screen is started, "All" has been selected. When "Changed" is selected, the list of the
parameters that have been changed from initial value is displayed.
(However, according to the specification of the robot type, some parameters might be changed before
shipment.)
It is possible to print only the parameters changed from initial value with RT ToolBox2 version 1.3 or later.
Please refer to "11.9. Parameter printing" in this manual for details.
11-163
Table 11-1 Compliant version of this function and controller
CR750-D/CRnD-700
Ver.1.1
not use
Ver.1.2
Ver.P6 or later
or later
Figure 11-5 List of parameter changed from initial value
Software version of robot controller
CR750-Q/CRnQ-700
not use
Ver.N6 or later
CRn-500
not use
not use
11-163