Mitsubishi Electric MELFA CR750 Series User Manual page 234

[Perspective rotation]
You can change the center of perspective rotation by enlargement/reduction mode with version 3.60N or later
of the software.
You can change the center of perspective rotation by presence of objects on center of the Robot View or
mouse position when you click on the Robot View.
enlargement/reduction mode
Zoom toward origin
Zoom toward screen center
Zoom toward mouse
However, double-click the left button, and operating mouse while holding down the left button, you can rotate
perspective around the origin without being affected by presence or absence of object, and
enlargement/reduction mode.
Also, if you're rotating operation of perspective around a point other than the point of origin, small coordinate
axes of the following will be displayed on rotation center point.
Caution
It may not be the expected rotation operation by the rotation of the
non-origin center.
If you rotate perspective around a point away from the
away from the center of rotation
[Perspective/Orthogonal
You can change the projection mode with
You can use this function with version 3.40S or later of the software.
3D monitor screen might not be normally displayed according to the environment used. (For instance, the
entire screen becomes black.)
In that case, please click
12-234
Table 12-5 Change the center of perspective rotation
State when you click the left button
Always
Opaque object exists in center of the
screen.
Opaque object doesn't exist in center of
the screen.
Opaque object exists in the mouse
position.
Opaque object doesn't exist in the mouse
position.
Figure 12-18 Center of perspective rotation
projection]
button of the toolbar.
origin, there is a case
buttons of toolbar.
Center of perspective rotation
Origin
Center of the screen
Origin
Mouse position
Origin
perspective move
12-234