User-Defined Area Parameter - Mitsubishi Electric MELFA CR750 Series User Manual

11.3.6. User-defined area parameter

You can specify the region (cuboid) defined with two points in the robot XYZ coordinates and set the behavior
for when the robot enters this region.
Set parameters while connected to the robot controller.
From the project tree, double click the target project [Online] -> [Parameter] -> [Movement parameter] ->
[User-defined area].
After you change the parameter value, you can rewrite the parameters in the robot controller by clicking the
[Write] button.
Ver.3.30G or later, you can switch between the coordinate system.
Figure 11-15 User-defined area parameter
You can reference explanations of displayed parameters by pressing the [Explain] button.
11-172 11-172