Mitsubishi Electric MELFA CR750 Series User Manual page 429

５． Check the range over which you will calculate the tact time.
Open the program whose tact time you will calculate. Check the contents of this range, then click the [OK]
button.
The tact time calculation is started. During tact time calculation, "Calculating tact time" is displayed on
the simulation operation screen. Do not perform any other operations until this display goes out.
Figure 17-71 Simulation Operation Screen During Tact time Measurement
６． The tact time measurement results are displayed.
When tact time measurement is complete, the "Take time calculation results" screen is displayed. The
tact time measurement results are displayed in ms [milli seconds].
The current tact time
measurement results
are displayed.
Figure 17-72 Tact time Measurement Results (The axis load level calculation is impossible.)
17-429
Figure 17-70 Checking the Tact time Measurement Range
"Tact time Calculation"
The tact time calculation
results are added
sequentially.
This information is cleared
when the simulation is
started again.
17-429