Movement Status - Mitsubishi Electric MELFA CR750 Series User Manual

(10) View
You can switch the values of the variables displayed on the variables monitor between hexadecimal
display and decimal display.
The variables that can be displayed in hexadecimal, see below.
Integer
Float
String
Location
As for the value displayed by the hexadecimal number, "&H" is added to the head of the value.

12.1.3. Movement status

You can check the robot current position, destination position, hand open/close status, etc.
* Destination position corresponds with RT ToolBox2 Ver1.1 or later.
From the project tree, double click the target project [Online] -> [Monitor] -> [Movement Monitor] -> [Movement
Status].
12-226
Table 12-2 16Variables that can be displayed in Hexadecimal
The displayed variable can be switched to the hexadecimal number /
the decimal number.
When it is 0 below the decimal point, it is possible to switch to the
hexadecimal number / the decimal number.
However, the value is the one within the range of -9999999 - 9999999.
The hexadecimal number is not displayed.
The hexadecimal number is not displayed.
Figure 12-6 Movement Status
12-226