Nokia ESB26 User Manual page 75

7.
Switch1(config)#protocol
Switch1(cfg protocol)#rapid-spanning-tree enable
Switch1(cfg protocol)#end
2. Enabling Static LAG on interfaces 1/1/1 and 1/1/4
Switch1#configure terminal
Switch1(config)#interface 1/1/1
Switch1(config-if 1/1/1)#link-aggregation static id 1
Switch1(config-if 1/1/1)#interface 1/1/4
Switch1(config-if 1/1/4)#link-aggregation static id 1
3. Enabling Static LAG on interfaces 1/1/17 and 1/1/20
Switch1(config-if 1/1/4)#interface 1/1/17
Switch1(config-if 1/1/17)#link-aggregation static id 3
Switch1(config-if 1/1/17)#interface 1/1/20
Switch1(config-if 1/1/20)#link-aggregation static id 3
Switch1(config-if 1/1/20)#end
Displaying the Configuration on Switch 1:
1. Displaying the static LAG configuration:
Switch1#show interface link-aggregation static
=========+======+=======================+=======================
Aggregate| Type | Management Name
---------+------+-----------------------+-----------------------
AG01 |static|TRUNK1
AG03 |static|TRUNK3
2. Displaying the RSTP parameter settings and Rapid-Spanning-Tree topology:
Switch1#show rapid-spanning-tree
Rapid spanning tree
ProtocolSpecification
Priority
TimeSinceTopologyChange = 41 (Sec)
TopChanges
DesignatedRoot
MaxAge
HelloTime
ForwardDelay
BridgeMaxAge
BridgeHelloTime
BridgeForwardDelay
TxHoldCount
MigrationTimer
DetectLineCRCReconfig
============================================================================
Port |Pri|Prt role|State|PCost
--------+---+--------+-----+---------+---------+-----------------+----+-----
AG01 128 Designat frwrd
AG03 128 Designat frwrd
MN700004 Rev 01
Link Aggregation Groups (LAGs)
| Ports
|1/1/1,1/1/4
|1/1/17,1/1/20
= enabled
= ieee8021w
= 32768
= 2
= This bridge is the root
= 20 (Sec)
= 2 (Sec)
= 15 (Sec)
= 20 (Sec)
= 2 (Sec)
= 15 (Sec)
= 3
= 3 (Sec)
= disabled
|DCost
10 0
10 0
64
|Designated bridge|DPrt|FwrdT
32768.00A0121102A3 128.88
32768.00A0121102A3 128.90
1
1