Nokia ESB26 User Manual page 308

25. Status Monitoring, Statistics and General Commands
The Server for remote synchronization may be any host running Windows NT/2000 or the
UNIX operating system. To configure the Daytime or Timeserver, refer to your system
documentation.
The no form of this command removes the timeserver definitions.
You can also synchronize the switch to observe the local daylight saving time in your area.
For details, refer to "Configuring Daylight Saving Time (DST)".
Command Syntax
device-name(config)#time-server {time|daytime} A.B.C.D <refresh-time> [ZONE]
device-name(config)#no time-server
device-name(config)#time-server summer-time recurring (first1|<N1>|last1)
DAY1 MONTH1 HH:MM:SS1 (first2|<N2>|last2) DAY2 MONTH2 HH:MM:SS2 <T>
device-name(config)#time-server summer-time date <d
<d > MONTH <yyyy > HH:MM:SS
2 2 2
device-name(config)#time-server daytime swap
The old style of this command, wherein the IP address argument (A.B.C.D)
NOTE
precedes the time|daytime is supported for backward compatibility. However,
Nokia strongly recommends using only the new style of the command for setting up
time synchronization clients.
For details on
Daylight Saving Time (DST)".
Argument Description
time Specifies "Time Protocol" (RFC868)
daytime Specifies "Daytime Protocol" (RFC867)
swap Swaps day and month (for daytime format). This would be required if the positions of
day and month are interchanged in the daytimeserver's format, to prevent the switch
from interpreting the day value as the month and the month value as the day.
A.B.C.D IP address of the timeserver
refresh-time Synchronization polling interval, in the range of <10-44640> minutes.
timeout Sets the timeserver session timeout in seconds. The range is <2-20> seconds.
<timeout>
ZONE Shift of local hour relative to the server (Positive East, negative West of server's time
zone).
Examples
1. The following command synchronizes the system time with host 192.168.0.1, using the
Time Protocol. Synchronization will be performed every 10 minutes. Local time is two
hours behind the server's time.
device-name(config)#time-server time 192.168.0.1 10 -2
2. The following command synchronizes the system time with host 192.168.0.1, using the
MN700004 Rev 01
<T>
2
time-server summer-time
297
> MONTH <yyyy > HH:MM:SS
1 1 1
command, refer to "Configuring
1