Configuration Example; Related Commands - Nokia ESB26 User Manual

34.
radius Debug RADIUS packets.
recv Debug packets sending and receiving.
send Debug packets receiving.
detail Debug packets sending.
Displaying the 802.1X Debugging
The show debug dot1x command, in Privileged (Enable) mode, displays the debug status for
the 802.1X. The debug commands can help the network manager to monitor a session as it
proceeds on the switch.
Command Syntax
device-name#show debug dot1x
Example
device-name#show debug dot1x
PBA core debugging
process
PBA Authenticator State Machine debugging is on:
status,events,timers
PBA Backend State Machine debugging is on:
status,events,timers
PBA RADIUS debugging is on: packet send,packet receive,events,
PBA EAPOL debugging is on: packet send,packet receive

Configuration Example

1. Set the RADIUS server and specify the IP address, key, username, password and AAA
authentication:
device-name#configure terminal
device-name(config)#radius-server host 9.0.0.26
device-name(config)#radius-server key hello
device-name(config)#username batm password a1h8RRzG11d4U
device-name(config)#aaa authentication login default radius local
2. Configure port 1/1/6 of the Authenticator for authorization, setting it to auto authorization
mode:
device-name(config)#interface 1/1/6
device-name(config-if 1/1/6)#dot1x port-control auto

Related Commands

The table below shows the 802.1X-related commands.
MN700004 Rev 01
802.1X Port-Based Authentication
is on: 802.1X
376
core process,Re-Authentication