Nokia ESB26 User Manual page 44

5.
The command changes the switch's configuration mode into Interface Configuration mode.
Following execution of the command, the prompt line displays the interface unit, slot and port
numbers. If you apply this command when the switch is in Interface Configuration mode, the
mode is changed to the specified Interface Configuration mode (for example, you can use this
command to change the mode from Interface 1/1/1 Configuration mode to Interface 1/1/2
Configuration mode).
When the switch enters interface-configuration mode, this is indicated by changing the
command prompt - it displays the interface unit and the slot and port numbers.
Command Syntax
device-name(config)#interface UU/SS/PP|range|agXX
device-name(config-if UU/SS/PP)#
device-name(config-if UU1/SS1/PP1)#interface UU2/SS2/PP2|range|agXX
device-name(config-if UU2/SS2/PP2)#
Argument Description
UU/SS/PP Represent the unit, slot and port numbers of the configured interface.
range Configures a group of interfaces at a time. Individual interfaces are
separated by commas, range is indicated with hyphen, e.g. 1/1/1, 1/1/2-
1/1/6. Entering Interface Group Configuration mode is indicated by the
command prompt changing to
agXX Link aggregation interface's name (e.g. ag01).
Example 1
Accessing Interface Configuration mode for interface 1/1/2
device-name(config)#interface 1/1/2
device-name(config-if 1/1/2)#
device-name(config)#
Example 2
Specifying a range of interfaces and changing the Spanning Tree path cost for them:
device-name(config)#interface range 1/1/4-1/1/6
device-name(config-if-group)#spanning-tree path-cost 200
device-name(config-if-group)#
Disabling an Interface
The shutdown command, in Interface Configuration mode, disables the interface (to receive,
forward and learn). The no form of this command enables the interface.
The shutdown command disables all functions on the specified interface. This command also
marks the interface as unavailable. To check whether an interface is disabled, use the show
interface command in Privileged (Enable) mode. An interface that has been shut down is
shown as administratively down in the display issued by the show interface command.
By default, the interface is enabled (active).
Command Syntax
device-name(config-if UU/SS/PP)#shutdown
device-name(config-if UU/SS/PP)#no shutdown
MN700004 Rev 01
Ethernet Interface Configuration
(config-if-group)#
33
.