Getting Started; Overview; Unpacking; Front Panel - Nokia ESB26 User Manual

2. Getting Started

Overview

ESB26 installation consists of inserting the card into the appropriate slot in the system,
turning the unit power on, and setting the IP Address in order to enable remote management.
All other management procedures may be performed remotely via Terminal Interface
management applications that are integrated into the unit.
This chapter describes how to install the unit, perform initial setup, use Terminal Interface
management applications, and how to perform basic switch operations.

Unpacking

After unpacking:
• Verify that the ESB26 unit has not been damaged during shipment.
• It is recommended that you keep the shipping package until the unit has been
installed and verified as being fully operational. As all electronic devices with
static sensitive components, ESB26 should be handled with care.

Front Panel

1000Base SX
ports
B
Table 2-1 ESB26 Front Panel Components
ETH1, ETH2 Two 1000Base SX ports interface connectors
MN700004 Rev 01
Open tabs outwards to insert or extract card
1000Base T
ports
Figure 2-1 ESB26 Front Panel
6
Operation indicator
Reset button
10/100Base
T/TX ports
A
Serial
connector