Nokia ESB26 User Manual page 280

22.
NOTE The TLS must be enabled before executing this command. To enable the TLS use the tls
enable command in Global configuration mode.
Command Syntax
device-name(config)#tls ethertype <number>
Argument Description
number Hexadecimal VLAN EtherType value.
Assigning the TLS Uplink to an Interface
The tls uplink command in Interface Configuration mode, assigns the TLS uplink to the
configured interface. To remove the TLS uplink, use the no form of this command.
The TLS uplink is configured at the Provider-network side of the provider-edge (PE) switch.
Note that the interface remains TLS uplink port until the TLS is globally disabled or changed
to TLS user.
NOTE The TLS must be enabled before executing this command. To enable the TLS use the tls
enable command in Global configuration mode.
The TLS uplink must be configured as tagged on the TLS VLAN.
Command Syntax
device-name(config-if UU/SS/PP)#tls uplink
device-name(config-if UU/SS/PP)#no tls uplink
Displaying TLS Configuration
Table 22-3 lists the TLS displaying commands.
Table 22-3 TLS Displaying Commands
C o m m a n d D e s c r i p t i o n
show tls Displays the global TLS configuration.
Displaying the TLS Configuration
The show tls command, in Privileged (Enable) mode, displays the TLS configuration:
•
The TLS status
•
The TLS EtherType
•
The TLS uplink ports
Command Syntax
device-name#show tls
MN700004 Rev 01
Transparent LAN Services (TLS)
269