Mvr Type - Nokia ESB26 User Manual

21.
address:
device-name(config)#no mvr group 228.1.23.1
7. The following example shows how to delete all previously configured IP multicast
addresses:
device-name(config)#no mvr group
8. The following example shows how to set the maximum query response time to 15 seconds:
device-name(config)#mvr querytime 15
9. The following example shows how to reset the maximum query response time to the
default setting 10 seconds:
device-name(config)#no mvr querytime
10. The following example shows how to set VLAN 2 as the multicast VLAN:
device-name(config)#mvr vlan 2
MVR Interface Configuration Commands
Table 21-2 summarizes the MVR configuration commands available in Interface
Configuration mode.
Table 21-2 MVR Interface Configuration Commands
C o m m a n d D e s c r i p t i o n

mvr type

Configures the port either as an MVR receiver port or as a source port.
mvr immediate Enables or disables the Immediate Leave feature of MVR on a port.
mvr group Statically configures the specified MVR group IP multicast address for the specified
VLAN ID.
no mvr Removes the configured port from the MVR ports list.
mvr type
The mvr type command, in Interface Configuration mode, configures the port either as an
MVR receiver port or as a source port.
Command Syntax
device-name(config-if UU/SS/PP)#mvr type {source|receiver}
Argument Description
source Configures the port as an uplink port that can receive multicast data for the configured
multicast groups. There can be more than one source port in a switch.
MN700004 Rev 01
Multicast VLAN Registration (MVR)
260