Nokia ESB26 User Manual page 67

7.
Argument Description
priority Priority value, in the range 1 (highest priority) to 65535 (lowest priority).
Example
The following command sets the LACP system priority to 1 (the highest priority).
device-name(cfg protocol)#link-aggregation lacp system-priority 1
device-name(cfg protocol)#link-aggregation lacp system-priority
System priority = 1
Enabling and Configuring an Interface for LACP Aggregation
The link-aggregation lacp command, in Interface Configuration mode, enables the
configured interface to be added to or removed from a LAG dynamically by the LACP. It also
sets LACP parameters. The no form of the command disables LACP on the configured
interface. The no link-aggregation lacp port-priority command resets the LACP priority of
the configured interface to the default value.
If port priority is specified without a value, the command shows the current value.
If no optional arguments are entered and the configured interface is not LACP-enabled, the
interface is configured with default argument values. If the interface is LACP-enabled, only
explicitly entered optional arguments take effect.
When an interface is set to LACP passive mode, it will not start to exchange LACP frames
until it receives such frames from the remote switch.
When an interface is set to LACP active mode, it will send LACP frames periodically (every
30 seconds). The exchange of LACP frames starts when the remote side answers.
By default, the LACP port is active with priority is 32768.
Command Syntax
device-name(config-if UU/SS/PP)# link-aggregation lacp [active | passive]
[port-priority [<priority>]]
device-name(config-if UU/SS/PP)#no link-aggregation lacp port-priority
device-name(config-if UU/SS/PP)#no link-aggregation
Argument Description
active
passive
port-priority <priority>
Specifying the STP/RSTP/MSTP Port Priority
STP/RSTP/MSTP port priority can be specified for aggregate ports in the same way as for
normal ports. For details, refer to the respective (STP/RSTP/MSTP) chapter.
MN700004 Rev 01
Link Aggregation Groups (LAGs)
Enable LACP in active mode (default).
Enable LACP in passive mode.
The port priority value, in the range <1-65535>.
56