Nokia ESB26 User Manual page 279

22.
Configuring TLS
To set the TLS, proceed as follows:
1. Enable TLS. See Enabling/Disabling the TLS.
2. Set the EtherType if you want settings other than the default. See Error! Reference
source not found..
3. Set the uplink ports. See Assigning the TLS Uplink to an Interface.
NOTE By default, all the ports are set as TLS users.
Table 22-2 lists the TLS configuration commands.
Table 22-2 TLS Configuration Commands
C o m m a n d
tls
tls ethertype
tls uplink
Enabling/Disabling the TLS
The tls command, in Global Configuration mode, enables or disables the TLS on the switch.
NOTE TLS cannot coexist with IGMP Snooping.
Command Syntax
device-name(config)#tls {enable | disable}
Argument Description
enable Enables the TLS.
disable Disables the TLS.
Setting the TLS Ethertype Value
The tls ethertype command, in Global Configuration mode, sets the EtherType value. By
default, the EtherType value is 0x9000.
MN700004 Rev 01
Transparent LAN Services (TLS)
D e s c r i p t i o n
Enables/disables TLS on the switch.
Assigns the EtherType value.
Assigns a TLS uplink to the configured interface.
268