Nokia ESB26 User Manual page 284

23.
C o m m a n d
copy running-config
download-from
copy running-config
upload-to
copy sysloader
swap application
copy application
The copy application command, in Privileged (Enable) mode, downloads a new software
version to the switch.
The image file contains the executable code that runs on the switch. It comes preinstalled
from the factory. As new versions of the image are released, you should upgrade the software
that is running on your system. The image is upgraded by using a download procedure from a
TFTP server on the network.
The primary application becomes secondary and stores the new image as a primary when you
use the option leave-primary-sw.
For more information about the dual boot feature, primary and secondary application of the
switch, refer to the "System Lodaer" chapter.
Command Syntax
device-name#copy application
A.B.C.D SOURCE_FILE
Argument Description
primary
secondary
leave-primary-sw
A.B.C.D
SOURCE_FILE
NOTE
Both images (the primary and the secondary) should be dual boot images.
MN700004 Rev 01
Software Upgrade and Reboot Options
D e s c r i p t i o n
Loads a running-configuration with the specified file name, from a
remote server with the specified IP address.
Saves the running configuration on the remote server with the
specified IP address to the specified file name.
Downloads a new sysloader version to the switch
Swaps the primary and secondary applications
(primary|secondary|leave-primary-sw)
Copies the image to the primary (first) flash.
Copies the image to the secondary (second) flash.
Moves the application from the first flash to the second and stores a
new image on it.
The IP address of the TFTP server.
The path and name of the source-file (located on the TFTP server).
Note that the path specification and any file-name limitations may
depend on the software running on the TFTP server.
273