Nokia ESB26 User Manual page 287

23.
TARGET_FILE The path and name given to the target file on the TFTP server.
Note that the path specification and any file-name limitations may depend on the
software running on the TFTP server.
Example
The following command uploads the running-configuration to a new file named RUN002, on
C:/ on the TFTP server at IP address 192.192.54.0.
device-name#copy startup-config upload-to 192.192.54.0 c:/RUN002
copy sysloader
The copy sysloader command, in Enable mode, copies the system loader.
Command Syntax
copy sysloader A.B.C.D FILE-NAME
device-name#
Argument Description
A.B.C.D. The IP address of the TFTP server.
FILE-NAME The path and name of the source-file (located on the TFTP server).
Note that the path specification and any file-name limitations may
depend on the software running on the TFTP server.
NOTE
Update of Sysloader software should be done only by instruction of Technical Support.
Powering down the switch in during sysloader save can prevent the switch from being
able to startup.
swap application
The swap application command, in Enable mode, swaps the primary and secondary
applications.
Command Syntax
swap application
device-name#
Write Commands
The Write commands, summarized in Table 23-2, can be used to perform the following
operations:
•
Display detailed information regarding the current configuration of the unit
on the terminal monitor;
MN700004 Rev 01
Software Upgrade and Reboot Options
276