Nokia ESB26 User Manual page 68

7.
Specifying the STP/RSTP/MSTP Path Cost
STP/RSTP/MSTP path cost can be specified for aggregate ports in the same way as for
normal ports. For details, refer to the respective (STP/RSTP/MSTP) chapter.
Displaying Link Aggregation Groups
Table 7-4 lists the commands to display the static LAG and LACP configuration.
Table 7-4 Commands to Display the Static LAG and LACP Configuration
C o m m a n d
show interface link-
aggregation
show link-aggregation lacp
Displaying the Link Aggregation Groups
The show interface link-aggregation command, in Privileged (Enable) mode, displays the
link aggregation groups in the system, as specified by the command arguments. If no
argument is specified, the list includes all static and dynamic link aggregation groups.
NOTE
The show link aggregation command replaces the show trunk command. The show trunk
command is also supported.
Command Syntax
device-name#show interface link-aggregation [static | dynamic | id <num>]
Argument Description
static Displays only the statically defined link aggregation groups.
dynamic Displays only the dynamic link aggregation groups, created by LACP.
id <num> Displays the link aggregation group that is specified by the ID number (Not used in this
version of the switch).
Example
device-name#show interface link-aggregation
==========+========+=================+=====================
Aggregate |Type
----------+--------+-----------------+--------------------+
AG01 | static | TRUNK1
AG03 | LACP
==========+========+=================+=====================
MN700004 Rev 01
Link Aggregation Groups (LAGs)
D e s c r i p t i o n
Displays the Link Aggregation Groups configuration.
Displays a list of all LACP-enabled interfaces in the system with
the configured LACP parameters.
| Management Name | Ports
| 1/1/3,1/1/5
| LACP3 | 1/1/14-1/1/16
57
|
|
|