Nokia ESB26 User Manual page 410

Commands to Configure the Switch from the Loader
The table below summarizes the CLI commands available upon entering Loader mode. The
commands are described in the subsections that follow.
Table APPENDIX-5 Loader Configuration Commands
C o m m a n d
config
mac-address
clean startup-
configuration
clean log-history
ip-address
config
The config command, in Loader Configuration mode, switches the CLI from initial mode to
Loader configuration mode.
Example
Loader>config
Loader(config)#
mac-address
The mac-address command, in Loader Configuration mode, displays or changes the MAC
address of the switch. If no optional parameter is entered, the current MAC address is
displayed.
Command Syntax
Loader(config)#mac-address [HH:HH:HH:HH:HH:HH]
Argument Description
HH:HH:HH:HH:HH:HH
Examples
1. Displaying the switch's current MAC address:
Loader(config)#mac-address
Current base MAC Address of switch = 00:A0:12:1B:00:60
OutBand MAC Address (base + 1) = 00:A0:12:1B:00:61
2. Assigning new MAC address to the switch. The response indicates that the new MAC
address is accepted and stored in the switch's memory.
Loader(config)#mac-address 00:a0:12:07:0f:78
New MAC Address of switch = 00:A0:12:07:0F:78
MN700004 Rev 01
APPENDIX
Loader, Sysloader and Dual Boot
D e s c r i p t i o n
Switches from Loader initial to Loader configuration mode.
Displays or changes the switch's MAC address.
Sets the startup configuration database in the permanent storage
memory to the default values.
Cleans all history records.
Configures IP address of the loader. (Used for manufacturing purposes
only.)
The switch MAC address.
V