Status Word For The Dcu Profile - ABB ACS560 Firmware Manual

452 Fieldbus control through the embedded fieldbus interface (EFB)


Status Word for the DCU Profile

The embedded fieldbus interface writes the drive Status Word bits 0 to 15 to the
fieldbus Status Word as is. Bits 16 to 32 of the drive Status Word are not in use.
Bit Name
0 READY
1 D
2 Reserved for
D_TO_ROTATE
3 RUNNING
4 ZERO_SPEED
5 ACCELERATING
6 DECELERATING
7 AT_SETPOINT
8 LIMIT
9 SUPERVISION
10 REVERSE_REF
11 REVERSE_ACT
12 PANEL_LOCAL
13 FIELDBUS_LOC
AL
14 EXT2_ACT
15 FAULT
Value State/Description
1 Drive is ready to receive the start command.
0 Drive is not ready.
1 External run enable signal is active.
0 External run enable signal is not active.
Not yet implemented.
1 Drive is modulating.
0 Drive is not modulating.
1 Drive is at zero speed.
0 Drive is not at zero speed.
1 Drive speed is increasing.
0 Drive speed is not increasing.
1 Drive speed is decreasing.
0 Drive speed is not decreasing.
1 Drive is at setpoint.
0 Drive is not at setpoint.
1 Drive operation is limited.
0 Drive operation is not limited.
1 Actual value (speed, frequency or torque) is above a
limit. Limit is set with parameters 46.31...46.33
0 Actual value (speed, frequency or torque) is within
limits.
1 Drive reference is in the reverse direction.
0 Drive reference is in the forward direction
1 Drive is running in the reverse direction
0 Drive is running in the forward direction
1 Panel/keypad (or PC tool) is in local control mode.
0 Panel/keypad (or PC tool) is not in local control mode.
1 Fieldbus is in local control mode.
0 Fieldbus is not in local control mode.
1 External control location EXT2 is active.
0 External control location EXT1 is active.
1 Drive is faulted.
0 Drive is not faulted.