ABB ACS560 Firmware Manual page 124

124 Control macros
erminal sizes
T
• (frames R0...R8): 0.14...1.5 mm
• Tightening torques: 0.5...0.6 N·m (0.4 lbf·ft)
Notes
1)
Current [0(4)...20 mA, R
input as selected with parameter 12.15 AI1 unit selection.
2)
Current [0(4)...20 mA, R
input as selected with parameter 12.25 AI2 unit selection.
3)
Total load capacity of the auxiliary voltage output +24V (X2:10) = 6.0 W (250 mA /
24 V). User can use this source for either of the I/O connections (DI1... DI2- RO1 or
DI3...DI6 - RO2~RO3).
4)
Connected with jumpers at the factory.
5)
Ground the outer shield of the cable 360 degrees under the grounding clamp on
the grounding shelf for the control cables.
6)
Can be used to set up pressure alarm warning.
7)
Can be used for cold start prevention with connection to 'temperature reached'
output of temperature controller or PLC
8)
Input signal
9)
Output signal
10)
For R0...R2 frames only
In addition, some inputs and settings are set automatically as follows:
No. Name (Input/Setting)
19.11 Ext1/Ext2 selection
19.14 Ext2 control mode
20.02 Ext1 start trigger type
20.06 Ext2 commands
20.07 Ext2 start trigger type
20.08 Ext2 in1 source
20.09 Ext2 in2 source
20.12 Run enable 1 source
22.22 Constant speed sel1
23.11 Ramp set selection
26.11 Torque ref1 source
31.11 Fault reset selection
For information on cable connection and drive operation, see Control Connections in
the Hardware manual (3AXD50000044998)
2
(all terminals)
< 500 ohm] or voltage [ 0(2)...10 V, R
in
= 100 ohm] or voltage [ 0(2)...10 V, R
in
Value
5 =
3 =
1 =
2 =
1 =
2 =
2 =
7 =
5 =
0 =
2 =
0 =
DI3
Torque
Level
In1 Start; In2 Dir
Level
DI1
DI2
DI6
DI4
DI5
AI2 scaled
Not used
> 200 kohm]
in
> 200 kohm]
in