ABB ACS560 Firmware Manual page 201

No. Name/Value
In1 Start; In2 Dir
In1 Start fwd; In2
Start rev
In1P Start; In2 Stop The sources of the start and stop commands are selected by
Description
The source selected by
signal; the source selected by
determines the direction. The state transitions of the source
bits are interpreted as follows:
State of source 1
(20.03)
0
0 - > 1
(20.02 = Edge)
1 (20.02 = Level)
The source selected by
start signal; the source selected by
the reverse start signal. The state transitions of the source
bits are interpreted as follows:
State of source 1
(20.03)
0
0 - > 1
(20.02 = Edge)
1 (20.02 = Level)
0
1
parameters 20.03 Ext1 in1 source
The state transitions of the source bits are interpreted as
follows:
State of source 1
(20.03)
0 - > 1
Any
Notes:
• Parameter 20.02 Ext1 start trigger type
this setting.
• When source 2 is 0, the Start and Stop keys on the control
panel are disabled.
20.03 Ext1 in1 source is the start
20.04 Ext1 in2 source
State of source 2
(20.04)
Any
0
1
20.03 Ext1 in1 source is the forward
20.04 Ext1 in2 source
State of source 2
(20.04)
0
0
0 -> 1 (20.02 = Edge)
1 (20.02 = Level)
1
and 20.04 Ext1 in2
State of source 2
(20.04)
1
0
has no effect with
Parameters 201
Def/FbEq16
2
Command
Stop
Start forward
Start reverse
3
is
Command
Stop
Start forward
Start reverse
Stop
4
source.
Command
Start
Stop