ABB ACS560 Firmware Manual page 194

194 Parameters
No. Name/Value
Temp sensor 2
excitation
Abs motor speed
used
Abs motor speed %
Abs output
frequency
Abs motor torque
Abs output power
Abs motor shaft
power
AO1 data storage
AO2 data storage
Other
13.13 AO1 forced value
0.000...22.000 mA /
0.000...11.000 V
13.15 AO1 unit selection
V
mA
13.16 AO1 filter time
0.000 ... 30.000 s
Description
The output is used to feed an excitation current to the
temperature sensor 2, see parameter
source. See also section
01.61 Abs motor speed used
01.62 Abs motor speed %
01.63 Abs output frequency
01.64 Abs motor torque
01.65 Abs output power
01.68 Abs motor shaft power
13.91 AO1 data storage
13.92 AO2 data storage
Source selection (see Terms and abbreviations
Forced value that can be used instead of the selected output
signal. See parameter 13.02 AO force
Forced value for AO1.
Selects the unit for readings and settings related to analog
input AO1.
Note: In firmware ASCL2 and ASCL4), this setting must
match the corresponding hardware setting on the drive
control unit. See chapter Electrical installation, section
Switches in the Hardware manual of the drive and the default
control connections for the macro in use in chapter
macros (page 101). Control board reboot (either by cycling
the power or through parameter
required to validate any changes in the hardware settings.
Volts.
Milliamperes.
Defines the filtering time constant for analog output AO1.
%
Unfiltered signal
100
63
Filtered signal
T
-t/T
O = I × (1 - e
I = filter input (step)
O = filter output
t = time
T = filter time constant
Filter time constant.
35.21 Temperature 2
Motor thermal protection
(page 168).
(page 168).
(page 168).
(page 168).
(page 168).
(page 168).
(page 198).
(page 198).
on page 162). -
selection.
96.08 Control board
t
)
Def/FbEq16
21
(page 82).
26
27
28
30
31
32
37
38
0.000 mA
1 = 1 unit
mA
Control
boot) is
2
10
0.100 s
1000 = 1 s