ABB ACS560 Firmware Manual page 199

No. Name/Value
Scalar (Hz)
Forced magn.
19.11 Ext1/Ext2 selection
EXT1
EXT2
FBA A MCW bit 11
DI1
DI2
DI3
DI4
DI5
DI6
Timed function 1
Timed function 2
Timed function 3
Supervision 1
Supervision 2
Supervision 3
EFB MCW bit 11
FBA A connection
loss
EFB connection
loss
Other [bit]
19.12 Ext1 control mode
Zero
Speed
Torque
Minimum
Description
Frequency control in scalar motor control mode (in scalar
motor control mode).
Motor is in magnetizing mode.
Selects the source for external control location EXT1/EXT2
selection.
0 = EXT1
1 = EXT2
EXT1 (permanently selected).
EXT2 (permanently selected).
Control word bit 11 received through fieldbus interface A.
Digital input DI1 (10.02 DI delayed
Digital input DI2 (10.02 DI delayed
Digital input DI3 (10.02 DI delayed
Digital input DI4 (10.02 DI delayed
Digital input DI5 (10.02 DI delayed
Digital input DI6 (10.02 DI delayed
Bit 0 of 34.01 Timed functions status
Bit 1 of 34.01 Timed functions status
Bit 2 of 34.01 Timed functions status
Bit 0 of 32.01 Supervision status
Bit 1 of 32.01 Supervision status
Bit 2 of 32.01 Supervision status
Control word bit 11 received through the embedded fieldbus
interface.
Detected communication loss of fieldbus interface A changes
control mode to EXT2.
Detected communication loss of embedded fieldbus interface
changes control mode to EXT2.
Source selection (see Terms and abbreviations
Selects the operating mode for external control location EXT1
in vector motor control mode.
None.
Speed control. The torque reference used is
reference speed control
chain).
Torque control. The torque reference used is
ramp out (output of the torque reference chain).
Combination of selections Speed and Torque: the torque
selector compares the speed controller output
reference speed control) and the torque reference
Torque ref ramp out) and selects the smaller of the two.
If speed error becomes negative, the drive follows the speed
controller output until speed error becomes positive again.
This prevents the drive from accelerating uncontrollably if the
load is lost in torque control.
status, bit 0).
status, bit 1).
status, bit 2).
status, bit 3).
status, bit 4).
status, bit 5).
(see page 273).
(see page 273).
(see page 273).
(see page 266).
(see page 266).
(see page 266).
on page 162). -
25.01 Torque
(output of the speed reference
26.74 Torque ref
(25.01 Torque
Parameters 199
Def/FbEq16
10
20
EXT1
0
1
2
3
4
5
6
7
8
19
20
21
25
26
27
32
33
35
Speed
1
2
3
4
(26.74