Fx 3G Series Main Unit (Transistor Output - Mitsubishi Electric Melsec-F FX3GC Series User Manual

FX /FX /FX /FX /FX
3S 3G 3GC 3U 3UC
Built-in Positioning Functions
2.5.2 FX Series main unit (Transistor Output)
3G
This section describes the transistor output specifications of the FX
simultaneous turning-on rate is restricted for the output extension units and the main unit. For details on this
restriction, refer to the following manual.
For MELSERVO Series amplifiers, use a sink input/sink output type PLC.
External voltage
Resistance load
Maximum
load
Inductive load
Open-circuit leakage current
ON voltage
14-point, 24-point
type
Response
time
40-point, 60-point
type
Circuit insulation
Indication of output motion
Pulse output terminals Y000, Y001, and Y002
To use the positioning instruction, adjust the load current of the NPN open collector to 10 to 100 mA (5 to 24 V DC).
*1. Y002 works as a high-speed response pulse output terminal only in 40-point and 60-point type main
units.
Item
Operation voltage range
Operation current range
Output frequency
PLC User's Manual - Positioning Control Edition
Item
All outputs
All outputs
All outputs
All outputs
All outputs
Y000, Y001
OFFON
Y002 or more 0.2 ms or less at 200 mA or more (at 24 V DC)
Y000, Y001
ONOFF
Y002 or more 0.2 ms or less at 200 mA or more (at 24 V DC)
Y000 to Y002 5 s or less at 10 mA or more (5 to 24 V DC)
OFFON
Y003 or more 0.2 ms or less at 200 mA or more (at 24 V DC)
Y000 to Y002 5 s or less at 10 mA or more (5 to 24 V DC)
ONOFF
Y003 or more 0.2 ms or less at 200 mA or more (at 24 V DC)
All outputs
All outputs
Description
5 to 24 V DC
10 to 100 mA
100 kHz or less
Series main unit. Note that the
3G
Refer to the FX
Transistor output specifications
5 to 30 V DC
The total load current of resistance loads per common
terminal should be the following value or less.
- 1 point output common:0.5 A
- 4 points output common:0.8 A
The total of inductive loads per common terminal
should be the following value or less.
- 1 point output common:12 W/24 V DC
- 4 points output common:19.2 W/24 V DC
0.1 mA or less at 30 V DC
1.5 V or less
5 s or less at 10 mA or more (5 to 24 V DC)
5 s or less at 10 mA or more (5 to 24 V DC)
Photocoupler insulation
LED is lit when the photocoupler is driven.
*1
are high-speed response output terminals.
2 Specifications
2.5 Output Specifications
Hardware Edition.
3G
Apx.
B - 31
A
B