Mitsubishi Electric Melsec-F FX3GC Series User Manual page 182

FX /FX /FX /FX /FX
3S 3G 3GC 3U 3UC
Built-in Positioning Functions
Setting value
*2
8
9 ~ E
F
*2. A device can only be specified if an FX
When using an FX
instruction turns ON, an operation error (error code: K6763) will occur, and the instruction will not cause any
operation.
*3. Y003 is available only when two high-speed output special adapters are connected to the FX
*4. After setting a number in the range of 9 to E for the interrupt input signal, if the corresponding Interrupt
Positioning (DVIT) instruction turns ON, an operation error (error code: K6763) will occur, and the instruction
will not cause any operation.
B - 138
PLC User's Manual - Positioning Control Edition
interrupt input command
Specifies a user
Pulse output destination device
*4 Do not specify these values.
Set "F" for a pulse output destination device if the device is not used for the Interrupt
Positioning (DVIT) instruction.
PLC below Ver. 2.20, if "8" is set and then the specified Interrupt Positioning (DVIT)
3UC
9 One-speed Interrupt constant quantity feed - DVIT Instruction
Description of setting
*2
for the interrupt input signal.
User interrupt input command
Y000
Y001
Y002
*3
Y003
/FX PLC Ver. 2.20 or later is used.
3U 3UC
9.3 Function and Operation
M8460
M8461
M8462
M8463
PLC.
3U