Mitsubishi Electric Melsec-F FX3GC Series User Manual page 192

FX /FX /FX /FX /FX
3S 3G 3GC 3U 3UC
Built-in Positioning Functions
3) For
D
2
When a high-speed output special adapter is used as a destination for pulse output on a FX
the output shown in the following table for rotation direction signals.
When a built-in transistor output is used as a destination for pulse output on a FX
FX PLC, use transistor output for signals rotation direction.
3UC
High-speed output special
adapter number
1st adapter
2nd adapter
The rotation direction ON/OFF status of the specified device is shown in the following table.
During execution of this instruction, however, do not use the output
ON/OFF status of device
specified by
B - 148
PLC User's Manual - Positioning Control Edition
, specify the rotation direction signal output device number.
D
2
If the number of output pulses specified by
ON operation will be performed in the forward rotation direction.
Forward rotation (Outputting pulses from
If the number of output pulses specified by
OFF operation will be performed in the reverse rotation direction.
Reverse rotation (Outputting pulses from
10 Variable Speed Operation (Variable Speed Pulse Output) - PLSV Instruction
Pulse output Rotation direction
destination device
= Y000
D
1
D = Y001
1
D = Y002
1
D = Y003
1
Rotation direction (increase/decrease current value)
10.3 Function and Operation
/FX
3S
output
Y004
D
=
2
D Y005
=
2
D Y006
=
2
D Y007
=
2
for other purposes.
D
2
is a positive number, the
S
D will increase the current value.)
1
S is a negative number, the
will decrease the current value.)
D
1
PLC, use
3U
/FX /FX /
3G 3GC 3U