Samsung Smart MBS RRH-P4 Installation Manual page 47

2600-00CTEIGAA Ver.
1) Install 1/2 inch feeders line from the RF port at the bottom of RRH-P4 to the RF
antenna.
2) Insert a heat shrink tube (jelly type) to each end of the installed 1/2 inch feeder lines,
then connect a Din type-male connectors to the RRH-P4's RF port and the RF antenna
port.
3) After installing the connector, shrink the heat shrink tubes using a heat gun.
© SAMSUNG Electronics Co., Ltd.
4.0
Din Type- Male Connector
1/2 in. Feeder Line
Heat Shrink Tube (Jelly Type)
Figure 2.13 Connecting RRH-P4 Feeder Line (1)
Smart MBS RRH-P4 Installation Manual/Ver.3.0
Detail 'A'
2-17