Samsung Smart MBS RRH-P4 Installation Manual page 121

2600-00CTEIGAA Ver.
© SAMSUNG Electronics Co., Ltd.
4.0
Figure C.5 Assembling the N type-male connector (LMR-400) (2)
Smart MBS RRH-P4 Installation Manual/Ver.3.0
5) Push the N Type-male body into the end of the
cable until it is solidly inserted to the pin connection
part of the N Type-male body. Make the shield
overlap over the N Type-male body. Then pull out
the clamp ring and reset it to the original position to
make the remaining shield folded.
6) Cut off the folded remaining shield using a cutting
device so that it does not protrude outside when
the clamp ring is inserted.
After arranging the shield, push up the clamp ring
toward a connector until the entire shield is covered.
7) Using a compressor and hexagonal dies,
pressurize the clamp ring to fix the cable and
connector.
8) Lift the heat shrink tube up to the connection point
on the connector, and shrink the heat shrink tube
using a heating gun.
C-5