Table of Contents
Advertisement
2600-00CTEIGAA
Ver.
E.3 Assembling Pressure Terminal
The procedures for assembling a pressure terminal to a cable are as follows:
Strip the Cable Sheath
1) After checking the inside length of a pressure terminal, mark the cable.
2) Adjust the length of a cutter blade according to the sheath thickness of the cable.
3) Push the clamp with a thumb a ccording to the cable size to secure a space for the cable.
4) Put a cable into a clamp, locate a blade on a marking position, and push it into the sheath.
5) Align the stripper to be perpendicular to the cable and rotate it more than two laps.
© SAMSUNG Electronics Co., Ltd.
4.0
Figure E.4 Stripping Cable Sheath (1)
Smart MBS RRH-P4 Installation Manual/Ver.3.0
E-5
Advertisement
Table of Contents
