Table of Contents
Advertisement
2600-00CTEIGAA
Ver.
ANNEX A. Sector Antenna Installation
A.3 Sector Antenna Installation
The method of sector antenna installation is as follows.
1) Put up an antenna pole and insert the sector antenna into the antenna pole using a
fixing clamp.
2) Set the antenna's up/down tilt to 0° and fix the fixing clamps at the top and bottom.
3) After tightening the fixing clamp, adjust the antenna up/down (tilt) depending on the
signal strength. The bolt of the guide clamp must be loosened, so the antenna angle can
be adjusted.
4) After setting the antenna angle, fasten the bolt of the guide clamp, which was loosened
previously. Regarding the nut, the double nut mounting should be used to prevent the
nut from coming loose.
Main Radiation Direction
A-2
4.0
Guide Clamp Bolt_3
Guide Clamp Bolt_2
Antenna Input Port
Figure A.1 Sector Antenna
Guide Clamp Bolt_1
Upper Fixing Clamp
Upper Guide Clamp
Pole
Guide Clamp Bolt_4
© SAMSUNG Electronics Co., Ltd.
Lower Guide Clamp
Lower Fixing Clamp
Advertisement
Table of Contents
